View Full Version : flashing problem
Hi guys just got the unibox hd1+ and went to flash it with the vix image pressed the up to start flashing lasted about 1-2 mins and then went into standby rebooted its self but now just says booting on the front screen and wont boot up from the usb stick no more and wont do anything apart from say booting.
any help would be appreciated
thanks mick
BubbleBalls
02-08-13, 22:11
Try a different USB.
Tapatalker
ive tried another one but no joy still the same
BubbleBalls
02-08-13, 23:01
I had issues with USBs before, hence the suggestion. Hopefully somebody familiar with Venton will reply soon. I've had a few boot problems in the past but always managed to get going - don't panic.
Give it a little time for a reply.
Tapatalker
Try updating the bootloader then reflash the image again.
http://www.world-of-satellite.com/showthread.php?29218-Bootloader-04-02-2013-for-Venton-Unibox-HD1-HD1
Try updating the bootloader then reflash the image again.
http://www.world-of-satellite.com/showthread.php?29218-Bootloader-04-02-2013-for-Venton-Unibox-HD1-HD1
thanks for the reply ive tried this and the usb ports just dont seem to be reading the usb sticks
Use a USB stick max size 8GB, user rear port. Format the stick with HP Tool http://www.world-of-satellite.com/showthread.php?45-USB-Format-Tool
is this for a pc as my mac does not open it
i have used disk utility on the mac and that formats the usb sticks fine so will this hp tool make any difference ?
what tutorial are u using im sure 1 of the tuts were worded slightly wrong if I remember correctly
had this round a freind who is abit more clued up and he had no joy it turns on and just says booting and wont read his usb to reflash it any ideas?
Hi Mickntori. I have the exact same problem on the Venton HD1. Have you found a resolve?:)
I've got the same problem!
I think the only way out is to flash the box again using the RS232 port on the back of the Venton.
I can't find any software that is compatable with the Venton, there is software for flashing using the RS232 for the Vu+ boxes but I don't know if it is safe to use on the Venton.
Does anyone know if it can be used? Or have a link to the Venton flash tool?
Many thanks.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.