View Full Version : [CrossEPG-Other] Cross WPF stuck on "loading data" on vix
Hello
I am running the box image on my speed lx2 and cross epg used to work fine until I updated the image recently.
Now, it downloads the data fine but gets stuck with spinner at the end when it is "Loading data" and just stays there.
I have setup a swap file as well but that has made no difference.
Sounds like your EPG is corrupt.
Menu > Setup > System > EPG > Load/Save/Delete > Delete EPG.
Then download it again.
Thanks for the quick reply. Just tried your suggestion and it is stuck at the same point with Vix logo spinning around. I have to turn it on and off to change channels now.
It's really frustrating and I have been putting up with it for few weeks. I reinstalled a slightly older image and it is doing the same thing.
What EPG sources are you using?
Andy_Hazza
09-11-15, 13:01
Also where are you storing your EPG data?
Sent from my iPhone using Tapatalk
Apologies for the delay in replying but I have been tinkering around after your suggestions.
I have got it working if I set it to download onto the flash memory. It gets stuck if saving to the memory stick. Why would that be?
DaMacFunkin
14-11-15, 22:06
The memory stick is repeatedly un mounting or isn't mounting at all, do not save EPG to flash.
Try a new stick maybe in a different slot or add a HDD and save to there.
Hi i'm having the same issue and just added a new post on this. Have you fixed it? im tinking of re-flashing.:confused:
I deleted the epg, then restarted gui and once started downloaded epg and all sorted.
I reflashed it but it did the same thing. Only thing that fixed it was moving the epg download to internal memory. Probably need to format the memory stick and try again.
Sent from my iPhone using Tapatalk
I reflashed it but it did the same thing. Only thing that fixed it was moving the epg download to internal memory. Probably need to format the memory stick and try again.
If your EPG is reverting to internal flash rather than the device it's set to save to, there's something wrong with your EPG device.
I changed it to save to flash memory as I was experimenting whilst trying to get it to work. It is working fine now though.
I will tinker with it again when I have a bit more time.
Sent from my iPhone using Tapatalk
frankblueking
19-11-15, 12:07
Hello
I am running the box image on my speed lx2 and cross epg used to work fine until I updated the image recently.
Now, it downloads the data fine but gets stuck with spinner at the end when it is "Loading data" and just stays there.
I have setup a swap file as well but that has made no difference.
I hope this empirical experiment helps. I also had freezing problems when trying to download using Crossepg. I lost my EPG data almost on a daily basis!! My EPG source is HMLTV and I save to a USB memory stick, although I flipped to HDD in frustration. Following the advice of the guys on this forum I deleted the EPG data, re-formatted the memory stick and re-flashed the image on a frequent basis but no joy. I then disabled the "auto save/reload" in the settings and only had HMLTV automatic download set. Since that change I have had no issues with my EPG. Interested to see what explanation our experienced guys have.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.