View Full Version : Nano SE refusing to Flash
starskyman
24-03-16, 12:07
This morning I have successfully flashed a VU Solo 2 with OpenVix 4. I have a Technomate ™-Nano SE that refuses to show the Update screen. Tried both USB ports, reformatted the USB clean and still no update screen. Any ideas!
Have you tried a different usb < 8gb
starskyman
24-03-16, 12:45
yes now tried it with a 4gb and a 2gb no luck. thanks for the repliy
Are they a decent make ? I had issues with cheapo ones and now only use Kingston.
abu baniaz
24-03-16, 20:16
How many USB devices conncted?
starskyman
24-03-16, 21:46
only one USB connected and Kingston USB
abu baniaz
24-03-16, 21:50
Try flashing with Image Manager
I've had one stuck before you could try a factory reset first then as Abu says try a different image like openatv via image manager, i got it working but I do remember it being tricky.
starskyman
28-03-16, 10:46
How do you get the image to be seen on a usb?
Andy_Hazza
28-03-16, 11:42
If you have an external hdd or any other usb's connected, disconnect them, only flash with the one usb which has your image on.
Sent from my iPhone using Tapatalk
starskyman
28-03-16, 12:52
where do I get the image from?
linsladeboy
06-04-16, 09:12
only one USB connected and Kingston USB
I always have to physically disconnect and reconnect from USB port with receiver powered ON when updating image , otherwise receiver does not recognise device.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.