View Full Version : Tune failed error message when turning dish
For some strange I'm now getting tune failed messages when for example the dish turns to 19.2e channels, or any other location.
I also tried to scan channels on 19.2 e and only picks up a limite number of channels and misses chanells like ZDF.
Tried restoring back up settings and still the the same tune failed?
Check your tuner settings. Ensure that e.g. 19.2E is set to USALS (if that's what you use). Check your coordinates are still correct.
Check your tuner settings. Ensure that e.g. 19.2E is set to USALS (if that's what you use). Check your coordinates are still correct.
Yep done that, so not sure why the problems is occuring. I see 28.2 e channels but when the dish turns to another saterlite it picks up some chanels but no all on the epg but no picture or sounds and says tune failed?
Could it be dish alignment?
Sounds liķe a problem with the dish. In positioner setup do a send to zero and then retry.
Ok, sorted the problem out, it was dish alignment as suspected
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.