View Full Version : help needed
biggchapp1818
03-11-17, 17:00
just recieved my miraclebox premium micro today flashed with openvix... went threw the setup process ..then i went to do a backup of image ..and says device ..there is a problem with this device please reformat it and try again...so went to information and about installed 1970-01-01..anybody help me with this also sent a ticket to support.....
Do you have a USB Flash drive pluged into the STB ? if yes then you need to Initialise it for the STB to recognise the flash drive.
As above for the backup error, regards the date, have you actually tuned to a signal feed? Do you have Ethernet connected?
Fully set the receiver up, scan & tune to a signal and the date should correct itself. The date is wrong because the receiver hasn't been fully setup, it will correct itself.
I think the date issue happens when setting up with no signal feed and Ethernet. Cant remember exactly.
biggchapp1818
03-11-17, 18:30
55241
here is the picture hopefully comes up ..think itsa reflash ?/
biggchapp1818
03-11-17, 18:31
no done all the above ...probs need to reflash what yiz suggest ..both boxes are the same ..nae drammers if i have 2 anyways sent tickets
no done all the above ...probs need to reflash what yiz suggest ..both boxes are the same ..nae drammers if i have 2 anyways sent tickets
OpenViX support is on the forum, not via WOS ticket system.
I wouldn't worry about the installed date being 1970-01-01 it is just linux format of a 0 date left from the manufacturer's or sponsor's setup. I have the same info on my miracle box. Just follow the advice given for the usb drive.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.