View Full Version : Symbol rate cap
Hi all,
Its the time of year I seem to spend a few dollars and am fixated with accessing a bird here in Australia with a 47,300 MSyms (https://www.lyngsat.com/Optus-D1.html) symbol rate!
Need some advice as the two DUO4KSE's I bought two years ago are excellent but not for the satellite I wanted.
Can the impressive AX HD61 cope to 50,000 say for my plan?
Help appreciated, actually any other boxes known to work into that range, I must really want a new Xmas gadget from WOS !! :rolleyes:
My Dish tuner goes to 65,000 at least so I can see it, just not in the HT.
Which satellite tuner do you have in the SE? I am using the later S2X version and can open 44000 symbol transponders.
By the way SF8008 is recommended for high SR and pretty effective blindscan.
Which satellite tuner do you have in the SE? I am using the later S2X version and can open 44000 symbol transponders.
By the way SF8008 is recommended for high SR and pretty effective blindscan.
The VU+DUO4KSE Tuner is NIM(45308X FBC) (DVB-S2X).
As an aside, I now have finally tuned one stream at a time, but it is not stable, if I reboot, there is no resolution until I tune from a DVB service to the stream which has been saved and it is then resolved (sort of triggers the decoding but it won't start on the service as it shows 0% signal until I tune down to an empty service then back to the stream that works).
How that came about is that I have the latest VIX image, updated the SATELLITE.XML and did a scan, presto, it resolves 47,300 SR on just one stream :cool:.
I am going to investigate an SCR/ Jess LNBF from WOS (not available in Australia), will that likely help?
Thank you for the reply and good on the SF8008, it looks a impressive unit.
this ?
https://www.lyngsat.com/Optus-D1.html
https://twitter.com/Apsattv/status/1523175423621799938/photo/1
this ?
https://www.lyngsat.com/Optus-D1.html
https://twitter.com/Apsattv/status/1523175423621799938/photo/1
Yes, the TP's for Australia are the ones I need (feeds, in clear), currently we have to use a CAM/ Government authorised broadcast called VAST (View Access Satellite Television) for FTA (Free To Air) services.
https://www.lyngsat.com/Optus-D3-10.html
The CAM+Card are paired by the host (Optus/ SingTel Communications) and cost users' from €145 ~ €364 approximately, channel changes are typically three seconds, boot time is a minute or so longer and some of the FTA services are no longer available on VAST.
:confused: Only in Australia for FTA.
Now I am confused. What do you need a CAM for? And you didn't tell us this is multistream.
Now I am confused. What do you need a CAM for? And you didn't tell us this is multistream.
The CAM is for the service I hope never to need again (see above) if, I can resolve the FTA feeds on D1.
Yes they are Multistream as per: https://www.lyngsat.com/Optus-D1.html
So sf8008 should work fine if you have the PLS codes. Codes may be in satellites.xml. Otherwise you would need an OS Mio 4k or 4k+ as these are the only boxes that can resolve the PLS codes from scratch.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.