AB-Com PULSe 4K SE only £99! FREE UK DELIVERY!
Superb quality and spec AB-Com PULSe 4K SE only £99! FREE UK DELIVERY! 4K UHD, Enigma 2, Multiboot 4 images & more!...
AB-Com PULSe 4k Rev II Twin tuner only £149! FREE UK DELIVERY!
Superb quality and spec AB-Com PULSe 4K Rev II Twin Satellite tuner only £149! FREE UK DELIVERY! 4K UHD, Enigma 2, SATA HDD facility, Multiboot 4 images & more!...

Monoblock Tuner configuration

afterburn

afterburn

Forum Supporter
Donated Member
Joined
Aug 7, 2014
Messages
259
Reaction score
0
Points
0
I have purchased a monoblock lnb in order to receive 19.2 and 23.5. I am looking for some help with the settings here. Any help appreciated.
 
Is that all I have to do. Do I need to specify the satellites ? the bottom 2 values are as follows
Set voltage and 22KHz yes
Send DISeqC only on satellite change No

Are these correct?
 
I'm trying this on an 80cm dish using a 4.3 degree monoblock. Any Experience of this abu? Difficult or not would you say?:confused:
 
A monoblock LNB in essence is just two LNBs in one housing and a built-in diseqc switch. It will work, but dishes have different sizes, so it is impossible to tweak adjustment properly because they are one block. I have only ever used a monoblock for 13/19. Provided the dish is aligned properly, it is easy. Just clamp the correct LNB. Your response in the other thread shows a good understanding of the principles of multi-LNB setup.
 
Thanks abu. Set this up today and worked fine. I have a perfectly acceptable single on both 19.2 and 23.5 (about 75%) so job done. :thumbsup:
 
You must log in or register to reply here.

OpenViX Feeds Status

Back
Top