[VU+ Solo2] Diseqc calibration

[tooner]

Hi

Tomorrow's the big day. I've got all my kit and I've a friend (who's good with heights) to do a pole install on a North facing wall with the dish looking South over the house. My plan is to use the satfinder on my phone to point the dish to a sat at 0.5W with the motor set to 0. I'm then going to get my box to point to a strong sat at 5W (which is closest to South from where I am in Ireland) and adjust left/right and elevation on dish to get the strongest signal using a simple meter.

The bit I'm not too sure about is the set up on the box and the calibration/alignment. I know I can set the long/lat in the settings, is there much else I need to know? Am I going about it the right way? I'm paying this guy by the hour so I want things to go as smoothly as possible.

Thanks in advance
tooner

 

[Stanman]

I use Urals on my Solo2.
Configuration mode is single
Mode is positioneenter your sat and long.

If everything is done correct dish will give to right sat.

Sent from my GT-I9305 using Tapatalk 4 Beta