Hi,
This is my first E2 receiver and I have some doubts on the motor configuration, with USALS I can catch all sats between 34.5ºW and 39ºE, my problem is the fine-tuning using the Positioner Setup.
My tuner configuration:
Tuner settings, Motor diseqc 1.2:
Advanced LNB 1, all sats from motorized dish
Priority - auto
LOF - universal LNB
Voltage mode - polarisation
Increased voltage - no
Tone-mode - band
Diseqc mode - 1.2
Tone-burst - none
Commited Diseqc command - none
Fast diseqc - no
Sequence repeat - no
Command order - committed, uncommitted, toneburst
Uncommitted diseqc command - input 1 (LNB from motorized dish connected to port one in one diseqc switch 1.1)
Diseqc repeats none
Longitude - 009.160 west
Latitude - 038.63 north
Use USALS for this sat - yes
Tuning step size - 0.360
Memory positions - 0.49
Horizontal TS - 2..3
Vertical TS - 1.7
1 - With USALS active can I use the Positioner Setup and store new positions?
2 - After saving the new position of one sat what happens to the other sats configured as USALS?... nothing or new positions will be calculated according to the satellite stored before?
3 - Where the new positions are stored?... in the receiver or in the motor?... if I flash the receiver will lose the stored positions?
I have some settings in the Positioner Setup:
. Tune and Focus -> Auto Focus - Calibrate - Calculate
. Goto -> Goto X - Goto 0
... I do not know what they do, can someone give me a short explanation?
This is my first E2 receiver and I have some doubts on the motor configuration, with USALS I can catch all sats between 34.5ºW and 39ºE, my problem is the fine-tuning using the Positioner Setup.
My tuner configuration:
Tuner settings, Motor diseqc 1.2:
Advanced LNB 1, all sats from motorized dish
Priority - auto
LOF - universal LNB
Voltage mode - polarisation
Increased voltage - no
Tone-mode - band
Diseqc mode - 1.2
Tone-burst - none
Commited Diseqc command - none
Fast diseqc - no
Sequence repeat - no
Command order - committed, uncommitted, toneburst
Uncommitted diseqc command - input 1 (LNB from motorized dish connected to port one in one diseqc switch 1.1)
Diseqc repeats none
Longitude - 009.160 west
Latitude - 038.63 north
Use USALS for this sat - yes
Tuning step size - 0.360
Memory positions - 0.49
Horizontal TS - 2..3
Vertical TS - 1.7
1 - With USALS active can I use the Positioner Setup and store new positions?
2 - After saving the new position of one sat what happens to the other sats configured as USALS?... nothing or new positions will be calculated according to the satellite stored before?
3 - Where the new positions are stored?... in the receiver or in the motor?... if I flash the receiver will lose the stored positions?
I have some settings in the Positioner Setup:
. Tune and Focus -> Auto Focus - Calibrate - Calculate
. Goto -> Goto X - Goto 0
... I do not know what they do, can someone give me a short explanation?
