[ET9x00] PowerTimer - Deep Standby - jobs running

[machare]

I created a new power timer for 'Go to deep Standby'. When it ran, it waited for 3 minutes and then told me that there were two jobs running. There were no recordings running.

How do I find out what the jobs are?

Can I change the delay from 3 minutes?

 

[Rob van der Does]

Under blue you can see any active jobs. Most likely this is a cam-check.
Anyway: if this happens the powertimer will be delayed by 5 mins.

 

[andyblac]

Under blue you can see any active jobs. Most likely this is a cam-check.
Anyway: if this happens the powertimer will be delayed by 5 mins.

just double checked the code , this delay is only done if the box is in standby, i will try to code for checking job tasks if not instandby, please bare with me, powertimer are really complicated stuff