[VU+ Duo2] Transcoding Setup Default problem

[shadowman007]

I think I may have found a problem with the latest image OpenVix Helios 010 in regards to the Transcoding setup. Well the problem seems to be only with the Bitrate and Frame rate settings everytime these settings are changed they go back to the default settings if the receiver in my case Vu+ Duo2 is either rebooted or enigma restarted? However if you put the receiver in Standby and "ON" it again the settings do not go back to default it's only when rebooted or enigma restarted. Also would like to point out this was not happening with my previous image OpenVix Zeus 023.

 

[Trial]

Hi,
did you disabled automatic mode?

ciao

 

[shadowman007]

Hi,
did you disabled automatic mode?

ciao

Hi, you mean the Auto Set Bitrate/Framerate option ? Yes this is OFF because if you ON this the option for manually setting Bitrate/Framerate disappears it only shows when this option is OFF.

 

[andyblac]

this should help,

https://github.com/oe-alliance/oe-alliance-plugins/commit/f470cc2a66a75b4043f6e73e9c00134706690f57


try again in next build. (011)

 

[shadowman007]

this should help,

https://github.com/oe-alliance/oe-alliance-plugins/commit/f470cc2a66a75b4043f6e73e9c00134706690f57


try again in next build. (011)

Hi, when will the 011 build be out?

 

[shadowman007]

this should help,

https://github.com/oe-alliance/oe-alliance-plugins/commit/f470cc2a66a75b4043f6e73e9c00134706690f57


try again in next build. (011)

Hi, thanks yes this problem has been sorted out on the latest build (012) Bitrate and Frame rate settings do not go back to default anymore after a reboot or enigma restart.

 

[Walt]

It's strange that the transcodes below 720p are all 4x3. Any ideas why that is the case?