[TM-NANO-3T COMBO] Spinning vix of death

[paulusone]

I have updated to 062 apollo but have had the spinning vix occur twice now whilst watching TV BBC digital the program continues to be viewed and the receiver will not respond to any commands and has to be a hard reset via power switch on rear this did not occur with previous build also there is no log produced? there are cccam and dreamplex addons installled with a 1TB drive

 

[Sicilian]

What image did you upgrade from? There was a driver update and kernel config update recently, maybe do a fresh flash and setup.

 

[paulusone]

An update to the above post after approx 20mins screen went blank and picture returned with command functions from remote returned have now updated to build 063

 

[paulusone]

The updates were 054 then 055 and 062 seemed OK with 055

 

[Sicilian]

I'd recommend fresh flash of 064 due to kernel config changes and drivers.

 

[DaMacFunkin]

Does 064 need to be a fresh flash or can we restore settings?
Thanks.

 

[abu baniaz]

Not all receivers have kernel/driver changes at same time.

 

[DaMacFunkin]

Didn't want to hijack this thread but my boxes are solo2 & duo2, so presume they do need fresh flash without settings restore.

 

[Sicilian]

Didn't want to hijack this thread but my boxes are solo2 & duo2, so presume they do need fresh flash without settings restore.

No, this was about the TM-N-3T.