[VU+ Solo2] Display 4.3 as fullscreen

[Rimmel]

Just upgraded a VU+ Solo2 and a ET9200 from Appollo 166 to Openvix 4.2.021.

On Appollo I could set Setup-system-av setting-.... Display 4.3 content to Just scale and the 4.3 black bars would disapear and the image would display fullscreen (stretched to fill).

On 4.2.021 this does not work.

Just scale seem to not work with 19.9 settings either. Letterbox seems to work though.

Anyone else had these problems?

Nothing has changed on the tv's. I literally just flashed a new image on each - fresh flash and no settings restore. Input all settings fresh manually.

Thanks

 

[Andy_Hazza]

Just Scale stretches things, just leave as it is (default settings)


Sent from my iPhone using Tapatalk

 

[DaMacFunkin]

If you watch a lot of 4:3 do not leave it at that ratio it will destroy the panel in your TV especially one susceptible to light burn.
Most TV manufacturers warn against it in the manual's.

 

[Rimmel]

Just Scale stretches things, just leave as it is (default settings)


Sent from my iPhone using Tapatalk

Yes I know it stretches things - that's what I want.

Hence the bit where I put.

Display 4.3 content to Just scale and the 4.3 black bars would disapear and the image would display fullscreen (stretched to fill).

 

[Rimmel]

If you watch a lot of 4:3 do not leave it at that ratio it will destroy the panel in your TV especially one susceptible to light burn.
Most TV manufacturers warn against it in the manual's.

So what you are saying is that by showing an image on the screen I may destroy the panel? haha It's way past April my friend.