[VU+ Ultimo] Adding timer crashes the box

[jukkal]

I online-updated my Vu+ Ultimo from Apollo 123 to 124.
Since the update log showed a driver update for Vu+, I tried if the qwerty keyboard had finally been fixed to work again.
I went to the remote code setup menu and turned the text support off.
After leaving the menus I pressed the green key twice to start the add timer function.
I didn't see the add timer screen, the receiver just crashed and rebooted.
After the reboot had finished, I tried again pressing the green key twice, and the box crashed and rebooted again.
I turned text support back on, then tried to go to "add timer" again, and the box crashed and rebooted again, this time showing the add timer screen before the tv went black for reboot.

I tried to send the logs from the receiver (about half an hour before sending this, there were three of them), but I am not sure whether they arrived or not.
I flashed back to Apollo 123 and only after that I realized the flashing erased the logs, so unfortunately I can't send them any more. Should have downloaded them to the computer before flashing.
Downgrading back to 123 apparently got the problem solved.

 

[london55dogs]

hi i have the same problem i updated my software from 123 to 124 and now i can't record using the timer at all it keeps crashing so am going back 2 the 123 in the mean time until the a new build comes out with it sorted

 

[judge]

Thanks for reporting, we're looking into the issue.

 

[birdman]

Not just adding a timer.

Attempting to look at a timer will also cause this issue.

The problem is in configList.py (modified for 124) - I think.

I have a crash log, if needed...(in fact I suspect I have 3....). EDIT. Sorry - they disappeared on me reverting to v123.

 

[judge]

Issue found & should be fixed in the next build.