[ET10x00] Change av input when box turns on

[joysleep1]

HI Guys

I was wandering if its possible that my TV will turn to AV number 3 whenever my box goes from standby to ON. My sky remote does not cycle through AV3 for some reason and i have to keep using my phone to change it to AV3 each time i turn on the receiver. It would be nice that when i take it out of standby mode, the TV will automatically change to that input.

Is this possible?

Thanks

 

[ronand]

It depends. Scart supports these functions but component connections don't carry the signals.

 

[ccs]

The tv remote has an input select button.

 

[joysleep1]

The tv remote has an input select button.

Yh but for some reason.. it does not cycle through to AV3.. I have lost the original remote aswell. How i make av3 one of the inputs it cycles though. Currently it cycles through my parents sky box another blank HDMI port (which i do not want to use), standard aerial and DVI or my PC that is there.

 

[joysleep1]

It depends. Scart supports these functions but component connections don't carry the signals.

Ok so there is no way it can do it itself then?

 

[abu baniaz]

Have you checked the setup, inputs menu on TV? You have to enable some inputs for them to be selectable.

 

[joysleep1]

Have you checked the setup, inputs menu on TV? You have to enable some inputs for them to be selectable.

Ok i will try that..

I was hoping that it could change itself when it comes off standby mode but i guess that is out of question. Is that feature ever or even possible though?

 

[ccs]

…. see #2.