[VU+ Duo2] Crash in transcoding setup screen

[Rob van der Does]

1. Open transcoding settings in OpenWebIf
2. Set 'Encoder 1: Auto mode (Bitrate/Framerate)' to Off
3. Set 'Encoder 1: Auto mode (Bitrate/Framerate)' to On
4. Now, to see the crash basically turn on and off auto-transcoding in the OSD UI using the Transcoding Addon.

Yep, reproduced indeed.

ad 4: using encoder 1.

 

[finbarr]

To be honest, it's not a major issue, and I have already done a fresh restore without settings backup. As outlined in step 10, I know the cause and workaround, so the severity is low, but still a valid crash at the end of the day.

Ok, I've figured out how to reproduce it (and work around it).

In my /etc/enigma2/settings file I see that have these transcoding options:

config.plugins.transcodingsetup.encoder.1.automode=On
config.plugins.transcodingsetup.encoder.0.gopframep=20
config.plugins.transcodingsetup.encoder.0.bitrate=200000
config.plugins.transcodingsetup.encoder.0.automode=On
config.plugins.transcodingsetup.encoder.0.framerate=23976
config.plugins.transcodingsetup.encoder.0.aspectratio=0
config.plugins.transcodingsetup.encoder.0.resolution=320x240

So if you init 4, add those to your settings file, then init 3, you will see the crash when turning on and off auto-transcoding in the UI.

 

[andyblac]

should be be in next build, thanks for the info.