[ViX_Misc] error no satallite or cable tuner is configured

[charlie96]

the wife has been pressing buttons and now i get the error no satellite or cable tuner is configured. ive tried in the menu and tried autobouquetsmaker and automatic scan. these say nothing to scan. it was working fine till the wife altered something. ive looked at manual scan (which i think shes messed with) but haven't got a clue what settings should be..........PLEASE HELP
ps ive just discoverd my epg seems to be in italian

 

[abu baniaz]

Check your tuner configuration.

menu, setup, service searching

 

[charlie96]

thanks

Check your tuner configuration.

menu, setup, service searching

tuner a bcm7346 (internal)(dvb-s2)
tuner b avl6211 (dvb-s2)
im afraid it may as well be written in mandarin.. sorry im just not clued up on what it should be or what to do if its wrong

 

[charlie96]

is there an option to restore to original settings

 

[abu baniaz]

You are on 3.2 037. I would recommend that you flash newer image and set it up again.

If you want to persist on current image, can you attach the settings file located in /etc/enigma2 You will have to zip it before you can attach it.

 

[charlie96]

once again sorry for sounding dumb but how do i flash a new image and set up again or attach file

 

[abu baniaz]

There is a link to a guide on how to attach files in my signature.

 

[charlie96]

i think ive just flashed a new image. however my box is now refusing to boot. its just been saying boot for the past ten minutes. does it take ages after this operation or have i killed it. simple step by step advice required please
many thanks
a very desperate charlie

 

[John1405]

Mine is down and all my friends are down I do not think that ta just your box there must be a problem

 

[charlie96]

mine was working fine till the wife tried to find strictly (which id already deleted from the file list) and so busy fingers got pressing allsorts. i ended up with epg in italian!!! and nothing else but errors. i think i managed to flash a newer version/image (it went through a loading process) now it just says boot on the box but doesnt come on. ive looked on the openvix site at the downloads but dont know which i need nor how to go about it. end result my box just wont boot up

 

[abu baniaz]

The flashing guides are here
http://www.openvix.co.uk/index.php/guides-and-tutorials/receiver-usb-flashing-guides/

Which image did you flash?

 

[abu baniaz]

The Vu solo 2 downloads are here
http://www.openvix.co.uk/index.php/downloads/vu-plus-images/vu-solo-2/

Newest image has highest number

 

[charlie96]

i went into image manager or somat and flashed the latest version. then i clicked on it and it went thro the loading procedure and said rebooting. but its just been stuck with boot on the screen for the last half hour. ive got the page link you sent me open in another tab but wich option do i need and how do i transfer it to my box.
many thanks again

 

[abu baniaz]

Yo don't transfer it to box. Please read the instruction on how to flash again, post which stage of the instructions you are stuck at.

Are you sure the receiver is genuine and not a clone?

 

[charlie96]

how can i do this my box wont boot. i can put a version on a usb stick and power up with stick plugged in but what do i need to download to the usb stick

 

[abu baniaz]

Use your PC to do the download and transferring. Not receiver.

 

[charlie96]

thanks abu.
however busy fingers has got me going up ladders now turning the house into blackpool illuminations so ill check back later with the latest
thanks again