Help Required Please to setup motor

[Tryharder]

I think your problem is that when you set the motor up originaly every satelite was given a number and position for eg 28.e position 28,,,19.2e position 19...etc. you should keep a record of whatever position you gave them. Then when you set up the Tuner you give each satelite the same number if you dont then it will not move to the requested Satelite..for eg. If you set 28e to position 1 then nothing will happen ..if you set it to position 19 it would move to 19.2e instead of 28e... I think you will have to reset the motor and start again. How you reset the motor differs so unless anyone here can explain it then you will have to refer to the manual..
I,m pretty sure this is your problem because i had exactly the same trouble a few years ago and i learned my lesson to keep a record of the motor settings for each satelite..
I hope this helps...

Rgds. Tryharder

 

[orm]

Hi, Thanks for this, I need to go up the ladder to perform the reset. Will let you know the result although may take a few days

Best regards

 

[abu baniaz]

Why don't you want to use USALS?