leshay
New member
Hi
This has been happening for last few updates.
I have a Power Timer to go to deep standby from standby after 10 minutes. However, every time it wakes up to record, the network connection is broken. No IP address and no Nameserver (as would be expected if no connection)
The only way I can get the connection back is to switch off/on via the rocker switch at back.
To try to fix this, I re-initialized the HDD, re-flashed, no settings restore, scanned, minimal settings changes just to get Network working, set a recording Timer for 30 minutes in the future and set a Power timer (Auto-deepstandby from normal standby) and tried it out. Result was Power Timer shut box down to deep standby and the Timer woke box up - recording OK, but *no* network connection.
This has been happening for last few updates.
I have a Power Timer to go to deep standby from standby after 10 minutes. However, every time it wakes up to record, the network connection is broken. No IP address and no Nameserver (as would be expected if no connection)
The only way I can get the connection back is to switch off/on via the rocker switch at back.
To try to fix this, I re-initialized the HDD, re-flashed, no settings restore, scanned, minimal settings changes just to get Network working, set a recording Timer for 30 minutes in the future and set a Power timer (Auto-deepstandby from normal standby) and tried it out. Result was Power Timer shut box down to deep standby and the Timer woke box up - recording OK, but *no* network connection.
Last edited:
