Missing some satellites after moving house

[Huevos]

Set USALS.

Point the motor physically south and tighten the clamp on the mast.

Make sure elevation setting on motor clamp is correct for your location.

Go in satfinder and select a transponder on 1 west. The motor should move a fraction.

Now adjust the dish around the motor stub for good signal on this transponder. Once adjusted it should work on all satellites.

 

[taximonkey]

Ok I don’t think I’m going to get any further with this until I can get back up at the dish and realign everything again. This will when friend brings long ladders and gives me a hand. Sorry if I’ve been a pain but I didn’t have to do this last time I tuned everything in manually with UsALS turned off but this wasn’t possible this time round. Thanks for your help guys I’ll give you all a shout when the dish has been adjusted �� lol