Hi. Just changed my satellite receiver (from technomate to cryptobox 752hd) and having problems setting up. Managed to find and store 8 positions all ok and works perfectly fine. I am using diseq 1.2 (dish not set up for usals). I have 28.2e to 0.8w all working. I can find and store 5w and 22w. I can scan the channels and watch them. When I move the dish to another satellite and then move back to either 5w or 22w the dish doesn’t move. It stays on whatever satellite I switched it to. I have disabled limits and even tried setting a west limit further than 22w but it makes no difference. I read that possible the sat position number may cause conflicts or even be too high for some motors / receivers (5w is number 58). I set up 5W on position 7 (unused) but it still didn’t work. Also I set up 5E (which I have no problems with) on a new satellite position (63) to see what would happen. I scanned and stored the channels, but when I moved to a different satellite the dish would not move back to my newly created position (even though it’s to a satellite that does work). I did try setting up 5w on this position too and again the dish wouldn’t move back there.
Has anyone any ideas please?
Has anyone any ideas please?
