Unable to read my card on smargo

[Idefixer]

Just recently I bought new Vu+Solo2, and tried to put my Via-card in it, but nothing happend. I checked logs and the internal reader does not read the card. Most likely the Vu+Solo2 does not have a internal reader that works with Via-vards..

So I took my smargo-reader and plugged it into the USB on the front of box. I tried to adress the card, both with protocol "smartreader" and "smargo" and changing the device-setting from /dev/ttyUSB0 to /dev/ttyUSB3, but no respons.

When I look in the structure in the box, I see that /dev contains sci0, sci1 and a lot of ttyxx and then ttyS0, ttyS1, ttyS2 and ttyS3.

But no ttyUSBx!

So my question is - Should I install some smargidriver OR should I use ttySx? And what kind of protocol?

Brg

 

[2stein]

imho your card should work in the card reader of the box.
however, you need to install a softcam like cccam, oscam, or the like.
the softcam will then read from sci0 or sci1.

 

[Idefixer]

Hi, I have Oscam, but it does not work

 

[rossi2000]

i am sure there are some smargo drivers on the feeds

ftdi or something, i could be wrong though