[VU+ Uno] Smargo not recognised on my 3.0 uno

[steve1978]

Hi all, I have just upgraded from the old 2.x image to the new 3.0 image and my smargo card reader isnt reaing my card , using cccam, cfg file is the same as it was before nothing has changed.

Any ideas?

 

[steve1978]

SOLVED, downloaded the usb serial driver from plugins.reboot, bingo

 

[Larry-G]

SOLVED, downloaded the usb serial driver from plugins.reboot, bingo

Nice to see you got it sorted buddy and this thread hopefully will also help any one else in a similar predicament.

Sent from my GT-I9300 using Tapatalk 2

 

[Donnie]

SOLVED, downloaded the usb serial driver from plugins.reboot, bingo

I must be blind, can you tell me exactly where you found that under plugins Steve1978 ?

 

[dfdream]

In Plugins...download plugins...its in Drivers....Its at the bottom of the list called usbserial (1,0-r0)
Install that and reboot and ensure that the conifg is OK in CCCAM.CFG

 

[Donnie]

In Plugins...download plugins...its in Drivers....Its at the bottom of the list called usbserial (1,0-r0)
Install that and reboot and ensure that the conifg is OK in CCCAM.CFG

They don't exist there for me, any other suggestions ?

 

[dfdream]

Try in the Plugins...remove plugins...its in Drivers you might have it installed already...
What is the last entry in the list of the Drivers in Download Plugins ?

 

[Donnie]

I installed the last one on the list already but it was not serial usb drivers

 

[judge]

Go to remove plugins & see if it's listed there.

 

[Donnie]

Thanks guys, I added usb drivers via packet management in software manager, removed the way you said and the reinstalled.

ALL GOOD :thumbsup: