[VU+ Solo2] Help me Please !

[pmos_hafi]

Dear Friends

after upgrading my solo2 to the last image , the stb looks for each direction , I see always the blinking motor figure at the top left and my stb doesn't tune any channels ! in some directions I get this message : No data on transponder ! (Timeout reading PAT)

Please help me to fix the problem .

Regards

 

[mann]

Dear Friends

after upgrading my solo2 to the last image , the stb looks for each direction , I see always the blinking motor figure at the top left and my stb doesn't tune any channels ! in some directions I get this message : No data on transponder ! (Timeout reading PAT)

Please help me to fix the problem .

Regards

Im not 100% sure but it sounds like a tuner problem...
flash an older image say 94/95 see if problem still exists

 

[pmos_hafi]

I have used the image 90 but still had the problem. I replace the cable from tuner A to B and changed the setting but still had the problem. Is it possible that both tuners go into a failure suddenly and after upgrading ? I have also changed the LNB and problem existed. I don't know what to do .

Regards

 

[pmos_hafi]

I have used the image 90 but still had the problem. I replace the cable from tuner A to B and changed the setting but still had the problem. Is it possible that both tuners go into a failure suddenly and after upgrading ? I have also changed the LNB and problem existed. I don't know what to do .

Regards

 

[Rob van der Does]

Moved to this section.

Please read this thread HERE