[TM-NANO-OE] HDD Installation

[Fhilipgreen]

Hi
Small niggling issue, installed my HDD 2 pin power etc all cabled. However when i power up my box nothing. Blanks screen no boot up. Remove the power to the HDD and all back to normal.

Any ideas?
Thanks

 

[timofee]

You could try formatting the HDD separately to exFAT, then try again.

If that does not work, try another HDD.

 

[abu baniaz]

The HDD is probably marked as having errors. An attempt is made to clean/fix before booting. Try formatting it in a PC first. Fat32 is better as receiver will mount it without having to install drivers.

 

[birdman]

Fat32 is better as receiver will mount it without having to install drivers.

...but will restrict you to 4GB file sizes.

 

[Andy_Hazza]

...but will restrict you to 4GB file sizes.

I think @abu meant easier for the receiver to recognise and mount before initialising it to Ext4.


Sent from my iPhone using Tapatalk

 

[bellejt]

not if you format it when in the box to EXT xxx

 

[birdman]

I think @abu meant easier for the receiver to recognise and mount before initialising it to Ext4.

It doesn't have to have a file system on it at all for the box to see it.

 

[bellejt]

normaly not but already had HDD's that needed to be reformatted on PC before beeing recognized by the boxes.

 

[birdman]

normaly not but already had HDD's that needed to be reformatted on PC before beeing recognized by the boxes.

That my depend on what you mean by "recognized". A raw device with no file-system on it will still be seen by the box as a raw device onto which a file system may be put. How enigma2 displays such an item I'm not sure.

 

[Fhilipgreen]

Thanks all it would appear that the power part of the sata cable was at fault. The unit now powers up as expected.

Thanks all