[DM920] Error message when checking the softcam

[ROGIII]

What type of support thread are you creating?

Support question

What OpenViX Image build number are you using?

6.8.001

Have you tried re-flashing WITHOUT settings restore?

NO

Have you tried re-flashing WITH a settings restore?

NO

After switching from 6.7.20 to 6.8.001 everything went fine.
When turning on the receiver, a message appears as in the attachment.
By confirming the message with the OK button, the message will disappear.
Do I need to do a new clean installation without transferring settings, or can the message be removed?
Can anyone please advise? Thank you

 

[abu baniaz]

Which softcam are you using please? And from where did you get it? Are you using softcam manager to control it or using the the script control method? If this is repeatable, can you enable debug logs and upload the debug logs. You must restart for setting to take effect.

 

[Huevos]

Which softcam are you using please? And from where did you get it? Are you using softcam manager to control it or using the the script control method? If this is repeatable, can you enable debug logs and upload the debug logs. You must restart for setting to take effect.

With that error message it must be SoftcamManager.

 

[ROGIII]

I use softcam manager from image. I use oscam-latest with my configuration files to read the Antik card on 16est.
I uploaded a new setting and restarted the receiver several times.
The error message has not appeared since then.
Thanks for the advice.

 

[ROGIII]

The error message started appearing again.
I reinstalled a clean install to version VIX6.8.001, all settings and add-ons reinstalled.
The error message no longer appears.