Frustration - Sky Q LNB / Gigablue 4K

[Hoopy1888]

Hi ladies and gents.
Have been a long time away from Enigma 2 and used to be pretty clued up.
However a few years away and i'm killing myself trying to get the old Gigablue 4K back up and running for basic freesat channels.
All i'm trying to do is set up the tuners to see the EL023 Wideband LNB


I've tried with one cable plugged into the tuners / two cables too..
I actually had it previously setup with one tuner (the option slot) as a motorised DiseqC1.2 and an old Sky LNB setup in the two other tuners(3 in total)

But now the LNB is wideband (after having SkyQ for a while) It's only seeing some of the frequencies when I scan.

What is the best settings / setup for the tuner(s) on the OpenVix Enigma 2 software?
I've tried to figure it out using previous posts but can't see anything definitive.

Any assistance greatly appreciated.

Kind regards
G

 

[twol]

If its not a Hybrid EL027/28 LNB then my understanding is that it is not supported…in which case just replace with a unicable lnb, which works well with the gigablue 4k receiver

 

[abu baniaz]

You can't use a Sky Q wideband LNB with any Enigma2 receiver. The unicable LNBs are best option, they come in 40mm collar sizes, so make sure you buy the adapter for it too if you decide to get that.

If you have the older universal sky LNBs they will work too. Two tuners will be independent and 6 will be internal loop through. Will be fine for most occasions.

 

[Hoopy1888]

I'm sure I have some old LNBs kicking about somewhere - will check what I have and try.
Thanks guys

 

[abu baniaz]

For universal LNBs. set the tuner/s with the signal wires as:
Simple, single, 28.2.

 

[Hoopy1888]

For universal LNBs. set the tuner/s with the signal wires as:
Simple, single, 28.2.

Tried that but no luck. Only finds a few channels

 

[Hoopy1888]

Tried that but no luck. Only finds a few channels

Sorry. Misread that. Yeah I tried in my motorised LNB and all is fine. I'll try a new LNB and that should work