[VU+ Duo] Manual Satellite Scan on Single Transponder

[redrobin]

Build 262 - Default Skin

Possible problem with Progress bar on Satellite scan not updating.

Did a manual satellite scan on a Single Transponder yesterday on 15W and the progress bar didn't progress neither did the %age. Exited the scan after a while and went back to the channel list, there was a new channel in the list.

Tried again today, on a Single Transponder on 28E, the progress bar didn't progress, but it did find channels and lists those immediately on completion of the scan.

Movement of the progress bar is re-assuring that something is happen, at the moment not sure if its scanning or not

 

[Larry-G]

Build 262 - Default Skin

Possible problem with Progress bar on Satellite scan not updating.

Did a manual satellite scan on a Single Transponder yesterday on 15W and the progress bar didn't progress neither did the %age. Exited the scan after a while and went back to the channel list, there was a new channel in the list.

Tried again today, on a Single Transponder on 28E, the progress bar didn't progress, but it did find channels and lists those immediately on completion of the scan.

Movement of the progress bar is re-assuring that something is happen, at the moment not sure if its scanning or not

The thing is on a single transponder a progress bar would not be of much use due to the quick scan time. You should of course see one if you do a full sat or service scan.

Sent from my GT-I9300 using Tapatalk 2

 

[redrobin]

The scan i did on 15W was running for over a minute without any indication of any progress, its not a problem, it would be just a re-assurance.

 

[Trial]

Hi,
one problem might be the time until lock which cannot be visualized with a bar and after lock it should be very fast.

ciao