[TM-TWIN-OE] New ViX Team Technomate TM-TWIN-OE ViX OE3.0 Release Discussion

[toploader]

Hi, I'd just like to clarify the part of the flash process that refers to NEW machines (those that haven't had an Enigma 2 image).

""3c) When powering on for first time after flashing with bootloader and image you MUST REPEATEDLY PRESS EXIT until the image boot logo appears after the initial splash screen""
""On NEW VIRGIN receivers that have never been flashed with an Enigma 2 image or required bootloader, you MUST repeatedly press menu for a few seconds after the Linux penguin splash screen appears, you will not see an image boot logo""

Question - Do I carry out BOTH of these steps ('exit' pressing until Pingu appears, then press 'menu') OR just the 2nd part ('menu' press after Pingu only)

Thanks in advance

TL

 

[abu baniaz]

Follow this post

http://www.world-of-satellite.com/s...ow-to-USB-flash-upgrade-Technomate-TM-Twin-OE

 

[russx]

Hi, im new to this site, just got a tm-twin-oe and have installed the bootloader and this software. Im using the box with a diseqc motor and it keeps failing to move the dish for no apparent reason. Sometimes can get it to work then it just stops again.
I noticed there are later versions of vix in the downloads section than this. Im trying to put a later version on but it wont let me upgrade the box.
Not sure if I have a dodgy box or its the software.

 

[Larry-G]

Which exact image do you currently have on the receiver ?. To find out Menu > Information > About.

Sent from my GT-I9300 using Tapatalk 2

 

[Rob van der Does]

Please report problems in your own, separate thread.