Hi All,
A couple of questions after flashing 5.4.003 onto my Solo2 a few days ago
1.
With the previous version i was using (eer... ver4.something - sorry) after a couple of hours of non-use it would go into deep standby.
After watching something or from standby, no problem.
Now though with 5.4.003 it just sits there in whatever state it is in.
I have tried a couple of different power timers but nothing's happening.
Any suggestions where to look?
2.
Trying to FTP files off through filezilla on win10, i can't connect to the solo2.
I'm using the same connection settings in filezilla as nothing has changed from that side, logging in with root/<nothing>, as that used to work.
The IP address is correct and i can use openwebif without any problems. Just not connect by FTP.
The FTP service is running (found it while looking for Samba), and so is telnet.
This happens from 2 different win10 machines, one using 20H2, the other on 1909. Both could successfully connect before the upgrade.
What else can i check?
3.
As FTP wasn't working, i thought i'd try getting a windows file browse session going (to copy stuff off)
I installed Samba and it's enabled/running after a reboot, but still can't connect from either win10 machine above.
I've seen NFS and uShare are not started though - are they necessary?
To be honest i'm not bothered whether both FTP or a file share works, so long as one of them does.
Any suggestions?
Cheers,
Mal
A couple of questions after flashing 5.4.003 onto my Solo2 a few days ago
1.
With the previous version i was using (eer... ver4.something - sorry) after a couple of hours of non-use it would go into deep standby.
After watching something or from standby, no problem.
Now though with 5.4.003 it just sits there in whatever state it is in.
I have tried a couple of different power timers but nothing's happening.
Any suggestions where to look?
2.
Trying to FTP files off through filezilla on win10, i can't connect to the solo2.
I'm using the same connection settings in filezilla as nothing has changed from that side, logging in with root/<nothing>, as that used to work.
The IP address is correct and i can use openwebif without any problems. Just not connect by FTP.
The FTP service is running (found it while looking for Samba), and so is telnet.
This happens from 2 different win10 machines, one using 20H2, the other on 1909. Both could successfully connect before the upgrade.
What else can i check?
3.
As FTP wasn't working, i thought i'd try getting a windows file browse session going (to copy stuff off)
I installed Samba and it's enabled/running after a reboot, but still can't connect from either win10 machine above.
I've seen NFS and uShare are not started though - are they necessary?
To be honest i'm not bothered whether both FTP or a file share works, so long as one of them does.
Any suggestions?
Cheers,
Mal
