Update Openvix Release 6.2.011

[woodpoleman]

I'm trying to update my Technomate TM-Nano M3 and Gigablue UHD Quad 4K to the latest Openvix Release. Earlier upgrades have been successful but being without a dish for while and may have left it a bit too long. I've followed the normal update process without success and tried earlier releases incrementally. I'm reluctant to do a factory reset without knowing the consequences. Your help will be appreciated. Thanks

 

[Huevos]

Just download the latest image in ImageManager and flash it. The process will do an automatic backup which you can restore in the install wizard.

 

[twol]

I'm trying to update my Technomate TM-Nano M3 and Gigablue UHD Quad 4K to the latest Openvix Release. Earlier upgrades have been successful but being without a dish for while and may have left it a bit too long. I've followed the normal update process without success and tried earlier releases incrementally. I'm reluctant to do a factory reset without knowing the consequences. Your help will be appreciated. Thanks

Factory reset just removes any settings, so you have a vanilla image

 

[woodpoleman]

Just download the latest image in ImageManager and flash it. The process will do an automatic backup which you can restore in the install wizard.

Thanks. Problem solved, fault was a corrupted usb drive.

 

[woodpoleman]

Thanks. Problem solved, fault was a corrupted usb drive.

Changed USB and flashed image 6.7.20 to TM Nano M3 in case of problem with 6.8. All was OK for a while until using the remote. Picture reduced to small window and wouldn't respond to remote. Turned it off and re-flashed 6.7.20 again OK for a while. It will reset itself by powering off and on again but various faults occur. I should add that my smallest USB is now 32GB is this a problem? Is there a way the box can be reset before flashing the VIX release. Thanks for any help.