[VU+ Duo2] back to previous channel button

[bellejt]

Now in img we can switch back from channel trough the < > buttons.This however is with a list choice.Would it be possible to program the < button for the list and the > button to automaticaly switch to the previous channel (without going trough the list).

 

[skippie]

yes this would be much appreciated if this would be possible again like it was in the past.

 

[BubbleBalls]

Is that option not available already? It's in one of the menu trees?


Tapatālker

 

[bellejt]

yes but not both functions at once.Or list or channel previous next.

 

[BubbleBalls]

I'll have a look again when I'm home but I remember two or three options being added after Andy initially changed it - Unless it changed again since.


Tapatālker

 

[bellejt]

thx for looking at it

 

[BubbleBalls]

Menu. Setup. System. Button setup. Button setup. History buttons mode - change to just zap. Green button.


Tapatālker

 

[Trial]

Hi,
disable panic button and use 0 for previous channel.

ciao

 

[bellejt]

how do i disable panic button and were is it ? I am using dutch language om the VU.

@bubbleballs : that only gives one choice.What I would like is to have the left button < for entire menu and the right button > for switching to last called channel.So I can easely switch between 2 channels.

 

[judge]

how do i disable panic button and were is it ? I am using dutch language om the VU.

Menu -> Setup -> System -> Channel selection settings -> Enable panic button

@bubbleballs : that only gives one choice.What I would like is to have the left button < for entire menu and the right button > for switching to last called channel.So I can easely switch between 2 channels.

Not currently possible.

 

[bellejt]

oke thx.That did the trick.Will use 0 to switch back.Maybe the combination I am looking for will come on the future.

 

[MrMister247]

Hi!

I have an ET6x00 and installed the latest OpenVIX-Image
Software
System OE: OE-Alliance 2.1
Distro: openvix
Firmware version: Helios.016
Driver date: 20130524
Kernel version: 3.8.7
Gui version: 2014-05-04

I tried to zap with 0 to the previous channel, but it does not work. I can not zap with < or > throuth the history. If I press 0 I see the first Channel (Number 1).

Do you have any idea?

Thank you for your support.

Greetings
MrMister

 

[MrMister247]

OK, I just found the "Panic Button" - Setting - Disabled and it worked.

My mistake...

Best regards,
MrMister