[VU+ Duo2] Manual Scan of transponders

[djz46]

This is just a minor thing I have found the other night while using the "Manual Scan" option in Vix image

setup/service searching/manual scan

My point is when you select "user defined" or "predefined transponder" it scans the selected transponder then proceeds to scan the whole satellite afterwards as well, which is very frustrating!

I am not sure if this is a bug with Hades 018 or not as i never had this problem before.

Cheers D

 

[Huevos]

That is because you have "Network" set to "yes".

 

[Joe_90]

Turn off "Network Scan" in the settings and it will scan just the transponder only and not the NIT (Network Information Table). On Astra most of the transponders are run by SKY or Freesat and if you scan the NIT it points to all the other transponders which are scanned in turn.

 

[djz46]

Thanks for that guys, i can honestly say i never noticed that i turned network scan to "yes" before now.

Thank once again.