[VU+ Solo2] USB Flashing Problem

[user68]

I'm trying to flash Apollo 121 using the USB. Vix installs but I can't pass through the initial set up wizard. It seems like my Solo2 isn't recognising the selection from my remote controller. I'm trying to select HDMI and move on through the wizard but it's not responding. It's just scrolling through the three selections repeatedly. I've replaced the remote controller batteries and have checked it's in STB mode. I've tried reflashing four times. No joy. Any help please?

 

[pembo]

have you tried reflashing to the previous version you had installed that you know worked ?

 

[user68]

I had Apollo 121 working well before (except for a problem with 1080P skins). I was only doing the usb flash to try to fix the 1080P problem. I'll try 120 and see what happens

 

[abu baniaz]

Are you sure mode of remote has not changed? You can use the webif remote to control it as a ge out of jail card until you sort code on remote.

 

[user68]

Same thing with Apollo 120. My remote was working perfectly well immediately before I reflashed. I can't get out of the wizard. Surely there must be a way to bypass the wizard and start Vix properly??

 

[user68]

Thanks Abu, I'll try that.

Are you sure mode of remote has not changed? You can use the webif remote to control it as a ge out of jail card until you sort code on remote.

 

[user68]

Thanks again Abu. You're a star. Panic over as the webif is allowing me to control the receiver. You must be right, the remote controller code must have changed.

Update; I've reset the remote and all's now back to normal.

 

[abu baniaz]

have a search for the codes.