[ABM-DVB-S/S2] Yet another "timeout for tuner lock" thread.

[Cohibastevie]

Hi Folks,

Long time since I've posted here, I got my Vu+ Solo2 about 2 years ago and it has honestly been bullet proof since setup so I have just been lurking for a while lol.

Here's my quandary...

my sat setup is as follows:

One fixed dish with 28.2E (directly connected to tuner A)
One fixed dish with multi lnb setup for 13.0E and 19.0E (both running into 4 way diseqc switch connected to tuner B)

I should also add that a feed from the 28.2E dish also goes into the diseqc switch essentially giving me 3 sats on tuner B.

I set my tuner B config up using diseq ABCD and the satellite selection to auto. The auto setup picks up the three sats immediately and assigns them to the correct ports. Signal strength on a manual test is in the 90s for each sat.

The problem is when using ABM for the providers on 13.0E and 19.0E. I get a "timeout for tuner lock" error when running ABM. I have tried selecting only skyUk and deselecting all other European providers and ABM runs without an issue. so it appears I only have this problem when trying to use AMB for the 13 and 19E providers.

I did do a manual scan and it appears I am picking up all applicable channels, but I would obviously like them in an easy to nav channel list.


Is there any suggestions you vix savvy guys could help me with?

Thanks in advance for any support.

Stevie.

 

[Huevos]

Does your tuner setup work fine in satfinder.

Try setting up advanced.

No problems with 13/19 and ABM here.

 

[twol]

Not sure what ABM locks on for 13 and 19 E, but perhaps you need to check out your lnb positioning and especially skew on the multi-lnb setup.
Both 28.2E and19.2 E run fine on abm for me, so not just a simple ABM problem.

 

[abu baniaz]

ABM support questions are better with debug logs attached.

http://www.world-of-satellite.com/showthread.php?44783-ABM-support-questions