Vu+ SOLO 2 remote control of TV & AMP

[jonmarkwright]

Hi All,

Not sure if this is the correct place for my post but as its probably a setting within the enigma 2 i have added it here.

My setup Sony TV, Onkyo Amp & VU+ Solo 2.
VU+ connects to the amp via HDMI and i then have a HDMI run out of the amp to the TV.
I currently have the VU+ remote setup to power on and off my TV via the TV Power Button.
Is there a way to setup this so I can literally press one button on the VU+ remote which turns off the VU+ box, tv and amp.
I'm sure it is possible but from my research and my current trialing it has not proved successful.

If anyone with a similar setup could point me in the right direction that would be great.

 

[jonmarkwright]

Any advice anyone. Really struggling with this

 

[Andy_Hazza]

Any advice anyone. Really struggling with this

I'm sure I came across an option to pair the Vu+ remote with the Onkyo Amp when I had mine, so I would look in the settings of the Onkyo or look in your manual.


Sent from my iPhone using Tapatalk

 

[jonmarkwright]

Right, we'll I'm very much closer through persistence and reading various posts on vu+ but more importantly on my amp. It appears that after setup the amp require switching off and on again. It was a little unclear so switched everything off then on again. Then as if by magic when I hit the vu+ stb button the vu+ goes into standby but then also switches the amp off and vice versa. Then after a little more playing with setting I now have the volume control on my amp not my vu+ box. So I'm now much happier but would also like the TV to switch off too . Iv played around but can't figure it out. It's not the end of the world as I can just press the TV power button the vu+ remote but just want it all done in one button press. Attached is my current vu settings any advice appreciated.