[VU+ Solo2] Wireless Pen Not Recognized After Reboot

[jorgeavlobo]

Situation:
- Running OpenViX on Open Multiboot as not the main flashed firmware.
- Vu+ Wireless USB Adapter.
- First run of OpenViX with ethernet cable and working internet connection.
- Inserted the Wireless USB Dongle after having internet with the ethernet cable.
- Wireless fully working after configuration and ethernet cable removed.
- After restarting the STB the wifi dongle appears with a red cross like if it was not installed (ethernet cable is no longer used).
- If I remove the wife dongle and insert it again, it will recognize it and I will be able to configure the internet again (ethernet cable is no longer used again).

Request:
- Make the STB recognize the wireless dongle after each restart without the need to remove and re-insert it and reconfigure it.

Thanks in advance for any help.
Merry Xmas everyone.

 

[judge]

ViX doesn't support multiboot, so unless you find the same results on a flash install and provide debug logs, little point in even looking into this.